Arduino Compatible L293D Motor Shield

$6.95

Part Number: HP-ASH-L293D

Ships from :

USA

COMING SOON 11/26

Available: 10+ Shipping Info*
Japan

IN STOCK

Available: 5+ Shipping Info*
China

BACKORDER

Available: 0 Shipping Info*

Get creative with your friends and families

The L293D Motor Shield is a very useful shield with standard components. It contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino. 2 connections for 5V 'hobby' servos connected to the Arduino's high-resolution dedicated timer: no jitter! 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes. Can run motors on 4.5VDC to 25VDC. Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5 percent resolution) Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping. Pull down resistors keep motors disabled during power-up Big terminal block connectors to easily hook up wires (18-26AWG) and power Arduino reset button brought up top 2-pin terminal block and jumper to connect external power, for separate logic or motor supplies

Arduino is a great starting point for electronics, and with a motor shield it can also be a nice tidy platform for robotics and mechatronics. Here is a design for a full-featured motor shield that will be able to power many simple to medium-complexity projects. 2 connections for 5V 'hobby' servos connected to the Arduino's high-resolution dedicated timer - no jitter!

Features:

  • Four H-Bridges: Two L293D Motor driver chips
  • L293D is rated at 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes
  • Motor Voltages from 4.5VDC to 16VDC. (up to 36V if C6 and C7 are upgraded)
  • Up to 4 bi-directional DC motors with individual 8-bit speed selection (256 speeds)
  • Up to 2 stepper motors (unipolar or bipolar)
  • Pull down resistors keep motors disabled during power-up
  • Separate Logic and Motor power connections
  • Terminal block connectors for motors and power
  • 2 connections for 5V 'hobby' servos

Included with the package:

  • Arduino Compatible MEGA Sensor Shield x 1

Specifications:

  • Architecture: Arduino
  • Motor Operating Voltage: 4.5 to 12V
  • Continuous Output Current: 1.2A
  • Logic control voltage Vss: 4.5~5.5V

*This is not a genuine Arduino product