Software:

The software itself can be downloaded at:

http://media.hyperion.hk/dn/pc/ecds-man/installer.zip

 

Current version is: 2011-12-14

 

Firmware:

Visit the EOS CHARGER Firmware Update site for the newest version:

Do note that v5.5 or later is REQUIRED. 

http://media.hyperion.hk/dn/pc/eosfw.htm

 

Please read Before you start

Changes are as follows:
2011-12-14
EOS Suite changes:
- Now support SiLabs 6.5 version, but you can choose to run any version from 6.1-current.
- This version support Bluetooth module connection if you choose to modify your chargers (see separate document)
- This Suite REQUIRE 5.50 firmware or later.
- New handling of battery size for the new firmware (Ah meter)
- All new connection routine for COM Port connection (for supporting BT modules) use BT as command line parameter
- Added a ECO mode for those want to lower the updates per second, nice if you have many chargers connected to a slow computer. use ECOMODE as command line parameter


Firmware changes:

- Choosing to charge NiXX type packs when you have connected a Lipo pack via balancer = Error
- NiXX type of charges will complain if Lipo is connected to balancer cable
- 1420 type chargers now allows for 36 & 48v PB charging.
- TVC now can be set at lower voltages to use as cutoff.
- LiXX type of battery now supports up to 100Ah packs.
- LiXX type of battery shows Ah nomination above 65000mah.
- PB now supports up to 200Ah packs.
- Ramp-up of charge now has a slight delay allowing for Generators to catch up.
- LCD of SuperDuo was updating/flashing too fast.
- Changes to Buzzer sound (now progress, button and end is separate settings)
- Internal watchguard function added in case of charger problem it will reset by itself as counter-measure.