Two or more chargers

When you connect two or more chargers, you MUST go through this procedure. This applies whether or not you choose to pair them.

1. Connect one charger only, start the program and press Yes on the questions about changing serial ID
2. Unplug the charger, close the program.
3. Plug in the second charger, start the program and again, press Yes on the questions.
4. Unplug the second charger, close the program
5. (repeat if you have more chargers)
6. Plug in all chargers and start the program.

 See Charger pairing if you want to set up two chargers as a single pair.

Note: When running more than one EOS0720 chargers you MUST have one USB cable to each charger even if they have a network cable connecting them